RELM GPH-CMD, Programming Instruction Manual, Page: 10 / 61

6 BK Radio Programming Manual
Press the [CLR] key to set the Time-Out Timer duration to zero.
Press the [ENT] key to store the changed setting and advance to the
next field.
scan delay time
After the Time-Out Timer is set, the upper display will indicate ‘PRG
SCN.’ This is the Scan Delay time in seconds.
Press the [FCN] key to advance to the next field if no change is
needed.
2.0 SEC
PRG SCN
Press the [PRI] key to increase the scan
delay time by .5 seconds, up to 7.5 seconds.
Press the [PRI] key again to change the time
from 7.5 seconds to 0.
Pressing the [CLR] key will reset the scan delay time to 0.
Press the [ENT] key to store the changed setting and advance to the
next field.
Priority 1 channel
After the Scan Delay is set, the display will indicate ‘PRG PR1.’ The
Priority 1 Channel can be programmed as a fixed channel, tied to
the Channel Selector knob, or programmed OFF. If the radio is
programmed to transmit on the Priority 1 Channel, transmissions will
occur on PR1, if PR1 isn’t programmed OFF, when operating in Single
or Dual Priority Scan Mode.
If PR1 is a fixed channel, and the [PRI] key on the keypad is not locked
out, during normal radio operation the user can move the channel
selector to a new channel and press the [PRI] key to choose a new
PR1 channel.
PR 1 ON
PRG
Press the [PRI] key to cycle through the
priority channel options, or enter a fixed
priority channel using the number keys.
Setting the channel to ON ties the PR1
channel to the Channel Selector knob. Pressing [CLR] or the [0] key
turns the PR1 channel OFF.
Press the [ENT] key to store the new priority channel and advance to
the next field.