RELM GPH-CMD, Programming Instruction Manual, Page: 18 / 61

14 BK Radio Programming Manual
channel settIngs
At the starting point for Channel 0, the display shows ‘PRG CH 00.’ At
this point, a channel number can now be pressed to allow access to per-
channel variables such as frequencies and Code Guard values for that
channel.
CH 01
PRG Press [1] and the display will show ‘PRG CH
01.’ This is the starting point for entering
channel 1 values.
Alternatively, pressing [PRI] will advance the channels one at a time.
channel bandwidth
CH 01N
PRG
At this point, pressing the [#] key will toggle
the channel’s bandwidth setting. An ‘N’ will
appear to the right of the channel number
when the channel is set for 12.5/15 kHz
channel bandwidth using the narrow band
receiver filter. When there is no ‘N’ the channel is set for 25/30 kHz
channel bandwidth.
receive frequency
151.62500
PRG RX
Press the [FCN] key and the upper part of
the display will show ‘PRG RX.’ This is the
receive frequency for channel 1 (in MHz).
If the displayed frequency is correct, press
the [FCN] key to advance to the next field.
If a new frequency is desired, press the [CLR] key followed by the
digits of the desired frequency. Then press the [ENT] key to store this
frequency and automatically advance to the next field.
receive mode
(Digital Models Only)
MODE -- X
PRG RX
After the receive frequency is set, the upper
part of the display will show ‘PRG RX’, and
the lower part of the display will show
‘Mode-X’, where X can be ‘A’ for Analog
Mode, ‘D’ for Digital Mode, or ‘M’ for Mixed
Mode.