RELM GPH-CMD, Programming Instruction Manual, Page: 38 / 61

34 BK Radio Programming Manual
When ANI/DTMF mode is set to ANI ONLY, the ANI ID number will be
transmitted (as a DTMF tone sequence) with each press of the PTT
switch. See “Automatic Numeric Identification (ANI)” for instructions on
setting the ANI number.
When ANI/DTMF mode is set to DTMF ONLY, the keypad becomes
active for manual DTMF operation.
When ANI/DTMF mode is set to ANI AND DTMF, the ANI tone
sequence will be transmitted only after the [ENT] key is pressed while
the transmit PTT switch is activated. A sidetone of the ANI number
transmitted will also be heard through the speaker.
Press the [PRI] key to cycle through the available settings.
Press the [ENT] key to store the changed setting and advance to the
next field.
backlight option
PRG TX RX SCN D CMND


home channel
T32 N4 G7
PRG TX RX SCN D CMND

KEY PRESS
BACKLIGHT
This step applies to DPH-CMD only.
Refer to “Option Group 2 - 7/8” for GPH-CMD.
The backlight can be triggered by different
events.
When BACKLIGHT is set to trigger on
KEY PRESS, the display backlight will illuminate each time a key is
pressed, even if pressing the key has no other effect. The display will
not illuminate if backlight duration is set to LITE OFF. See “Backlight
Duration” below.
When BACKLIGHT is set to trigger on DSPLY CHNG, the display
backlight will illuminate each time the display receives input. This
includes displayed changes in the selected channel or scan channel,
and the PR, TX, and SCN annunciators. The display will not illuminate
if Backlight Duration is set to LITE OFF. See “Backlight Duration”
below.
The BACKLIGHT can also be set to trigger on KEYPRESS OR
DISPLAY CHANGE.
Press the [PRI] key to cycle through the available settings.
Press the [ENT] key to store the setting and advance to the next field.
Press the [FCN] key to advance to the next field if no change is
needed.