RELM GPH-CMD, Programming Instruction Manual, Page: 49 / 61

RELM Wireless Corporation 45
ch 00
PRG
5. Put the Master radio in Programming
Mode by pressing and holding the master
switch then pressing and holding the [FCN]
key until the display shows ‘- - - ID.’
Enter the password of the selected group.
The display shows ‘PRG CH 00.’
6. Review the values programmed in the radio by pressing the [FCN]
or [ENT] key at each CHXX prompt. Any required changes must be
made now.
7. Connect the other plug of the cable to the side connector of the
radio you want to clone.
8. Turn on the clone and set it to the desired channel group.
prog
PRG
9. Press the [*] key on the Master radio
keypad. The display will flash ‘PROG’
signifying that the radio is ready to
download its program to the clone.
clone
PRG
10. Press the [FCN] key on the Master
radio keypad. The display will flash ‘CLONE’
while information from the master is
downloaded to the clone.
11. If the download was successful, the display on the master will
resume flashing ‘PROG.’
• To clone another channel group, turn off both radios and go back
to Step 3, changing the channel group as required.
• If cloning is finished, turn off the clone and disconnect the cloning
cable. Normal radio operation will occur when you turn on the clone.
fail
PRG
12. If the download was not successful, the
master will display ‘FAIL’ and multiple beeps
will follow. Failure of downloading can be
due to:
• Improper connection
• Failure to turn on the clone
• Setting the clone in Programming Mode
• Group ‘locked’ by PC Programming
NOTE: To stop the ‘FAIL’ Mode, press [CLR], turn off both radios, and
try again, starting with Step 1 on the previous page.