RELM GPH-CMD, Programming Instruction Manual, Page: 23 / 61

RELM Wireless Corporation 19
talk group Id
(Digital Models Only)
tg XXXXx
PRG TX ID

The next field is the Talk Group ID. This
value is only used if the transmit mode
selected was Digital or Mixed, or if User
Code Guard is activated. The upper part of
the display will show ‘PRG TX ID’ and the phone icon. The lower part
of the display will show ‘TGXXXXX’ where XXXXX is the Talk Group ID.
If the displayed value is correct, press the [FCN] key to advance to the
next field.
If you wish to change it, press the [CLR] key followed by the digits for
the new TGID, then [ENT] to store the new value and automatically
advance to the next field.
secure selection
(Encrypted Radios Only)
sec xxx
PRG TX ID
In radios equipped with DES/AES
encryption, the next field is the Secure
Transmit setting. This selection will not
appear in radios that do not have the
encryption option.
The upper line of the display will show ‘PRG TX ID’, and the lower part
of the display will show ‘SEC-XXX’, where XXX can be ‘CLR’ to always
transmit a clear signal, ‘ENC’ to always transmit an encrypted signal or
‘SW’ where the transmission can be selected via a programmed switch.
NOTE: To use the ‘SW’ selection one of the radios toggle switches
or [FCN] menu selection must be programmed with for the ‘Transmit
Secure’ selection. These settings require the use of the PC Radio
Editor LAA0744X.
If the mode is correct, press the [FCN] key to advance to the next field.
If a new mode is desired, press the [PRI] key to cycle through the
mode settings. Press [ENT] to store the new mode and automatically
advance to the next field.
encryption Key
(Encrypted Radios Only)
key 01
PRG TX ID
In radios equipped with DES/AES
encryption, the next field is the Encryption
Key setting. This selection will not appear in
radios that do not have the encryption
option.