49
h) Pitch Curve Setting „Pitch Curve“
This menu is only available if a helicopter with variable pitch function or swash 90°, 120° or 140° was
selected in the system settings menu!
Just like the throttle curve, the pitch curve can be individually set in all five points. It is no matter whether you are using
a model with only one pitch servo or the swash plate is controlled by three servos at once.
Setting the pitch curve:
• Switch on the transmitter and call the function setting menu.
• Move the cursor arrow to the menu item „Pitch Curve“ with the
two buttons „UP“ and „DOWN“.
• Briefly push the button „OK“ to activate the menu item.
The display shows the indications for the percentage setting
values for the five points of the pitch curve (L, 1, 2, 3 and H),
the control curve chart and the flight condition „Normal“ (the
switch „SWB“ has to be in the front position for this).
The vertical dash in the chart marks the position of the pitch
control stick.
In flight condition „Normal“, the values of the pitch curve
should be reduced a little to keep the curve flatter. The model
helicopter will thus be controllable more easily and delicately
in hover flight this way.
• Pushing the buttons „UP“ or „DOWN“ selects the percentage
input value for the bottom point of the pitch curve in the flight
condition „normal“. If the button „OK“ is pushed and held, the
factory parameters are called.
• When briefly pushing the button „OK“, the cursor arrow will
jump to the pitch curve setting point „1“. Push the buttons „UP“
or „DOWN“ to set the percentage input value for this point.
• Repeat this process until you have set the desired value for
the flight condition „Normal“ in all five points.
• Now operate the toggle switch „SWB“ to call the flight condi
-
tion „Idle up“.
Figure 43
Summary of Contents for HT-6
Page 1: ... Remote Control HT 6 2 4 GHz Item no 1310037 Version 04 15 7 ...
Page 69: ...69 ...
Page 70: ...70 ...
Page 71: ...71 ...