41
b) Servo End Deflection Setting „End Points“
Using the servo end deflection setting you can precisely define the maximum size of servo travel that is permitted on
each side. The servo end deflection function is typically used to protect servos from mechanically hitting an obstacle
when deflecting to the full extent. You can set a value from 0 to 120%. The smaller the value, the shorter the servo
travel.
Always try to select the linkage points on the servo and the rudder sticks so that they reach maximum rudder
deflections at the factory preset value of 100%.
The linked rods or sticks should not hit anything or be under any mechanical tension. This ensures that this
function is only required to make minimal adjustments. The rudder travel values given in the model operating
instructions which may be less than the maximum possible rudder travel values can be reduced later on with
the dual rate function.
Setting the servo end deflection:
• Switch on the transmitter and call the function setting menu.
• Move the cursor arrow to the menu item „End points“ with the
two buttons „UP“ and „DOWN“.
• Briefly push the button „OK“ to activate the menu item.
In the display you will see display items for the six control func-
tions with the currently set servo end deflections.
• Move the control stick for channel 1 all the way to the left and
then adjust the maximum possible servo deflection of the left
side with the buttons „UP“ and „DOWN“.
• Then move the control stick for channel 1 all the way to the
right and then adjust the maximum possible servo deflection of
the right side with the buttons „UP“ and „DOWN“. If the button
„OK“ is pushed and held, the factory parameters are called.
• When pushing the button „OK“ briefly, the cursor arrow will
jump to channel 2. The servo deflection of channel 2 is set by
the same principle as in channel 1.
• Repeat his process until you have set the correct servo end
deflections in all six channels.
• Keep the button „CANCEL“ pushed for a longer period to save
the settings. The display then shows the function setup menu
again.
• Push the button „CANCEL“ repeatedly until you get back to
the operating display.
Figure 36
Summary of Contents for HT-6
Page 1: ... Remote Control HT 6 2 4 GHz Item no 1310037 Version 04 15 7 ...
Page 69: ...69 ...
Page 70: ...70 ...
Page 71: ...71 ...
