34
i) Control Stick Assignment „Sticks Mode“
As described previously for the receiver connection, the individual receiver outlets (channels) have specific functions
or servos assigned to them. The first four outputs are assigned as follows:
CH1 = channel 1 (aileron/roll servo)
CH2 = channel 2 (elevator/nod servo)
CH3 = channel 3 (throttle servo/flight controller)
CH4 = channel 4 (rudder/tail servo)
When setting the control stick assignment, you can exactly
determine the control stick you want to use to control outputs
1 - 4.
Setting the control stick assignment:
• Switch on the transmitter and call the system setting menu.
• Move the cursor arrow to the menu item „Sticks mode“ with the
two buttons „UP“ and „DOWN“.
• Briefly push the button „OK“ to activate the menu item.
The display shows the currently used control stick assign-
ment. The two circles with the lines offset by 90° are the two
control sticks. Additionally, the control functions are displayed
according to the control stick assignment.
• Pushing the buttons „UP“ or „DOWN“ permits setting the desi
-
red control stick assignment „Mode 1“ to „Mode 4“.
• Keep the button „CANCEL“ pushed for a longer period to save
the settings. The display then shows the system setup menu
again.
• Push the button „CANCEL“ repeatedly until you get back to
the operating display.
Please observe that the control sticks are designed for „Mode
2“ or „Mode 4“ ex works. If you prefer „mode 1“ or „mode 3“,
the stick units must be swapped.
Figure 29
Summary of Contents for HT-6
Page 1: ... Remote Control HT 6 2 4 GHz Item no 1310037 Version 04 15 7 ...
Page 69: ...69 ...
Page 70: ...70 ...
Page 71: ...71 ...
