![background image](http://html.mh-extra.com/html/reely/ht-6/ht-6_manual_1432072016.webp)
16
* Electric models with an electronic flight controller only require a separate rechargeable receiver battery if the
flight controller used does not have a BEC circuit. For further information, refer to the technical documents of the
controller.
Channels 5 and 6 can be assigned differently depending on
model. There also is the option of operating two servos via a
V-cable at a receiver output.
For a possible setup or distribution of the control channel, see
the adjacent sketches in figure 9.
If a model is equipped, e.g. with two aileron servos, the second
servo can be connected to a receiver output that has not been
assigned yet. The control is then performed via one of the three
freely programming mixers.
For more information on the servo connection and the mixing
functions, see the following chapters (programing of the remote
control transmitter) in the respective function.
Important!
It is recommended to use a pair of tweezers or long-nosed pliers to disconnect the connection. To prevent
cable breaks, you should always pull on the plastic casing of the plug to disconnect the connection. Never
pull on the cables.
b) LED Display
The receiver has an LED display that serves mainly as an indicator for the receiver condition on one side (see figure
8, item 2).
The LED is lit only when the transmitter is on and bound to the receiver in operation of the receiver. If the transmitter
does not recognise any valid transmitter signal, the LED flashes. More information on the transmitter binding can be
taken from chapter: Binding Function.
Figure 9
Summary of Contents for HT-6
Page 1: ... Remote Control HT 6 2 4 GHz Item no 1310037 Version 04 15 7 ...
Page 69: ...69 ...
Page 70: ...70 ...
Page 71: ...71 ...