28
Receiver voltage „RX battery“
Depending on the receiver voltage supply used, this menu can be used to set the voltage values where the remote
control visually and acoustically displays threatening deep discharge.
To set the receiver voltages, proceed as follows:
• Call the „RX Setup“ menu.
• Use the buttons „UP“ or „DOWN“ to select the menu item „RX
Battery“ and activate it with the button „OK“.
• Use the buttons „UP“ and „DOWN“ to set the lowest voltage
value „Low“ that is already selected with the cursor arrow. If
the button „OK“ is pushed and held, the factory parameters
are called.
• Briefly push the button „OK“ to switch to the next-higher volta
-
ge value „Alarm“. The setting is made with buttons „UP“ and
„DOWN“ again.
• Use the button „OK“ to switch to the voltage value at fully char
-
ged rechargeable battery „High“ and again set the required
value with the buttons „UP“ or „DOWN“.
• Keep the button „CANCEL“ pushed for a longer period to save
the set voltage values. The display then shows the system
setup menu again.
• Push the button „CANCEL“ repeatedly until you get back to
the operating display.
Since the adjustable voltage values depend on each
other, it may be required to increase the voltage value
for a fully charged rechargeable battery first, to then
be able to enter higher alarm values as well.
If the set thresholds are undercut, the battery icon for
the receiver battery will flash at operation of the remo
-
te control and the remote control transmitter will make
warning or alarm sounds.
Figure 23
Summary of Contents for HT-6
Page 1: ... Remote Control HT 6 2 4 GHz Item no 1310037 Version 04 15 7 ...
Page 69: ...69 ...
Page 70: ...70 ...
Page 71: ...71 ...
