21
a) Model Memory Selection „Model Select“
The remote control system has 20 model memories which allow you to save the data for your respective models
independently of one another. Therefore, it is required to set the associated model memory in the transmitter before
operating a specific model.
Setting the model memory:
• Switch on the transmitter and call the system setting menu.
The top menu item „Model select“ is marked by the cursor
arrow.
• Briefly push the button „OK“ to activate the menu item.
The display shows the currently activated model memory.
Additionally, the model name and a model type figure are dis
-
played.
• Push the buttons „UP“ or „DOWN“ to select the desired model
memory 1 - 20.
• Keep the button „CANCEL“ pushed for a longer period to ac
-
tivate the desired model memory. The display then shows the
system setup menu again.
• Push the button „CANCEL“ repeatedly until you return to the
operating display and check if the desired model memory is
set.
If you want to switch the model memory even though
the receiver is still on, the display shows a warning
note that the receiver must be switched off before a
model memory change.
Figure 16
Figure 17
Summary of Contents for HT-6
Page 1: ... Remote Control HT 6 2 4 GHz Item no 1310037 Version 04 15 7 ...
Page 69: ...69 ...
Page 70: ...70 ...
Page 71: ...71 ...
