60
m) Gyro Sensitivity Setting „Gyroscope“
This menu is only available if a helicopter model was selected in the system settings menu!
So-called gyroscope (or gyro) systems are used in order to stabilise the tail of the helicopter in the air. There is a
connection between the receiver and the tail servo. If the tail turns sideways as a result of a wind gust or other external
influences, this is recognised by the gyro and a corresponding control command is sent to the tail servo to counter the
turn. Gyroscope systems that have an additional controller input permit setting the individual sensitivity for each flight
condition separately and independently of each other. This requires the controller input for the gyro to be connected
to channel 5 of the receiver.
For further information, refer to the design documents of the gyro system.
Setting the gyro sensitivity:
• Switch on the transmitter and call the function setting menu.
• Move the cursor arrow to the menu item „Gyroscope“ with the
two buttons „UP“ and „DOWN“.
• Briefly push the button „OK“ to activate the menu item.
The display shows the current switching condition of the gyro
sensitivity, the flight condition „Normal“ (the switch „SWB“ must
be in the front position for this) and the set value. The cursor
arrow in the mixer function shows that the gyro sensitivity now
can be activated or deactivated.
• Pushing the buttons „UP“ or „DOWN“ can activate „On“ or
deactivate „Off“ gyro sensitivity.
• When pushing the button „OK“, the cursor arrow will jump to
the setting value for gyros sensitivity.
• Push the buttons „UP“ or „DOWN“ to set the gyro sensitivity for
the flight condition „Normal“. If the button „OK“ is pushed and
held, the factory parameters are called.
Figure 52a
Summary of Contents for HT-6
Page 1: ... Remote Control HT 6 2 4 GHz Item no 1310037 Version 04 15 7 ...
Page 69: ...69 ...
Page 70: ...70 ...
Page 71: ...71 ...
