22
b) Model Name Setting „Model Name“
In order to be able to discern between model memories more easily it makes sense to give the memories the name of
the corresponding models. The name can consist of a combination of up to 8 letters, numbers or characters.
Caution, important!
You can always change only the name of the model memory that is active at the moment. If you want to
change the name of another model memory, you need to call and activate the desired model memory first.
Setting the model name:
• Switch on the transmitter and call the system setting menu.
• Move the cursor arrow to the menu item „Model name“ with
the two buttons „UP“ and „DOWN“.
• Briefly push the button „OK“ to activate the menu item.
The display shows the currently set model memory with the
model name. The first letter in the name is already backlit back
and can be set.
• Push the buttons „UP“ or „DOWN“ to select the desired letter
now. The arrow pointing to the right at the lower display edge
indicates that the remaining letters and special characters are
available on a second display page.
• To switch to the second letter, briefly push the button „OK“.
The second letter then gets a black background. If you push
the button „OK“ and hold it, the model name set ex works is
called.
The second letter is set according to the same pattern as the
first one.
• Repeat the above procedure until the desired model name has
been programmed.
• Keep the button „CANCEL“ pushed for a longer period to save
the set model name. The display then shows the system setup
menu again.
• Push the button „CANCEL“ repeatedly until you return to the
operating display and check if the desired model name is set
correctly.
Figure 18
Summary of Contents for HT-6
Page 1: ... Remote Control HT 6 2 4 GHz Item no 1310037 Version 04 15 7 ...
Page 69: ...69 ...
Page 70: ...70 ...
Page 71: ...71 ...
