63
o) Throttle Switch „Throttle Hold“
In order to be able to practice an autorotation landing, you need to uncouple the motor function from the pitch stick
using a toggle switch. The combustion engine must be at sufficient throttle so that the centrifugal clutch is reliably
open. Nevertheless, the motor should be set so that it spontaneously takes in gas and can be restarted immediately
if the situation so requires.
The function can also be used as a safety switch. If the model is carried to the starting point after starting up the
combustion engine, the throttle switch can be activated. Accidental adjustment of the throttle control stick then will not
lead to undesired revving up of the engine.
Setting the throttle switch:
• Switch on the transmitter and call the function setting menu.
• Move the cursor arrow to the menu item „Throttle hold“ with
the two buttons „UP“ and „DOWN“.
• Briefly push the button „OK“ to activate the menu item.
The display shows the current switching condition of the
throttle switch and the set value. The respective setting of the
toggle switch for the throttle switch is also displayed at the
lower edge of the display. The display „Not engaged“ shows
that the throttle switch is deactivated. „Engaged“ means that
the throttle switch is activated.
• Pushing the buttons „UP“ or „DOWN“ can activate „On“ or
deactivate „Off“ the throttle switching.
• When pushing the button „OK“, the cursor arrow will jump to
the setting value for throttle switching.
• Pushing the buttons „UP“ or „DOWN“ permits setting the
throttle servo with activated throttle switching so that the motor
will securely run through in idle operation. If the button „OK“ is
pushed and held, the factory parameters are called.
• Keep the button „CANCEL“ pushed for a longer period to save
the settings. The display then shows the function setup menu
again.
• When pushing the toggle switch for throttle switching, the mo
-
tor has to switch between the set idle speed and the speed
corresponding to the current position of the control stick for the
throttle function.
• Push the button „CANCEL“ repeatedly until you get back to
the operating display.
Figure 54
Summary of Contents for HT-6
Page 1: ... Remote Control HT 6 2 4 GHz Item no 1310037 Version 04 15 7 ...
Page 69: ...69 ...
Page 70: ...70 ...
Page 71: ...71 ...
