46
Voltage display (ill. 3, pos. 5)
The current voltage of the batteries or rechargeable batteries is displayed:
9.5 V or more: sufficient voltage.
9.4 V or less: change the batteries or charge the rechargeable batteries before flying.
8.9 V or less: You have less than 10 minutes before the remote control fails due to insufficient voltage. Land the model
safely immediately and change the batteries/charge the rechargeable batteries.
8.5 V: With a voltage of 8.5 V, you have at most 4 minutes to safely land the
model before the remote control fails. A battery icon also blinks on the display
and the remote control signals an alarm to alert you of the dangerous situation.
Alarm message with activated mixers
This display appears when turning on the transmitter. An acoustic alarm sounds
as well if the switches "Constant rotation speed" (ill. 1, pos. 5) and/or the flight
status converter for normal resp. aerobic flight are activated (ill. 1, pos. 19).
Both functions must first be turned off so that the transmitter is reset to normal
operating mode.
Data loss alarm
If the main memory of the remote control has lost the data required for flying,
the display shown on the side appears. Turn the remote control off and then on
again to reload the data. The memory slot number from 1 to 6 is displayed for
which the data is currently being restored. Never turn off the remote control
during this process, otherwise data restoration is cancelled. Once data slot
numbers are no longer displayed, you can turn the remote control off and on
again.
If the display shown on the side appears permanently after reactivating the
remote control, there is a graver error because all data is lost. Contact the
service department in this case.
Attention!
Do not operate any model in this case under any circumstances!
Unpredictable reactions of the receiver system may cause grave
damage to persons or property!
Ill. 5
Ill. 4
Ill. 6
Ill. 7
Summary of Contents for 20 55 15
Page 134: ...134 ...
Page 135: ...135 ...
