&
User
AN-80i
Manual
70-00072-01-08b
Proprietary Redline Communications © 2009
Page 40 of 128
June 4, 2009
change from 16 QAM 3/4 to 16 QAM 1/2). The level can be set from 0 to 7
(recommended value = 2).
Uncoded
Burst Rate [Mb/s]
: Select the desired UBR for the link. When Adaptive
Modulation is enabled, this sets the AN-80i maximum transmit rate. When Adaptive
Modulation is disabled, the AN-80i will transmit using only the specified UBR.
Table 5: Web - PTP Modulation/Coding vs UBR
Channel
Sizes
(MHz)
3.5 5 7 10 14 20 28 40
Modulation
Coding
Uncoded
Burst
Rate
(Mbps)
64 QAM
3/4
9.5 13.5 19.0 27.0 38.0 54.0 76.0 108.0
64 QAM
2/3
8.4 12.0 16.8 24.0 33.5 48.0 67.0 96.0
16 QAM
3/4
6.3 9.0 12.5 18.0 25.0 36.0 50.0 72.0
16 QAM
1/2
4.3 6.0 8.5 12.0 17.0 24.0 34.0 48.0
QPSK
3/4
3.1 4.5 6.3 9.0 12.5 18.0 25.0
36.0
QPSK
1/2
2.1 3.0 4.3 6.0 8.5 12.0 17.0
24.0
BPSK
3/4
1.6 2.3 3.2 4.5 6.3 9.0 12.6
18.0
BPSK
1/2
1.0 1.5 2.0 3.0 4.0 6.0 8.0 12.0
Channel Width [MHz]
: Select the channel bandwidth. Refer to Table 70: Spec. -
Regional Identification Codes on page 123 for available channel widths.
Ethernet Follows Wireless
: Check this box to have the AN-80i disable and enable
the Ethernet port function based on the status of the wireless interface. This feature
allows switches and routers to trigger configuration changes based on changes to the
AN-80i Ethernet port status.
Disabled ( ): The AN-80i Ethernet port is always enabled.
Enabled ( ):Ethernet port is controlled based on the status of the wireless interface.
Important
: The Ethernet Follows Wireless setting affects all data and management
traffic (HTTP, TELNET, and SNMP). While activated, it is not possible to manage the
AN-80i using the Ethernet port.
Table 6
:
Web - PTP Ethernet Status Indication
Wireless interface Status
Ethernet Port Status
Link Up
Enabled
Link Down
Disabled
Ethernet follows wireless timeout [sec]
: Enter the period (in seconds) the Ethernet
port will remain disabled following loss of connectivity on the wireless interface.
Following this interval, the Ethernet port will be automatically re-enabled to allow
management of the AN-80i.
Important
: When Ethernet Follows Wireless Timeout is enabled, external
switches/routers monitoring the Ethernet port must be programmed not to switch
automatically when the Ethernet port function is restored -- the wireless interface may
not be operational.
