Redline Communications RedCONNEX AN-80i, User Manual

Page: 76 / 128

&
User
AN-80i
Manual
70-00072-01-08b
Proprietary Redline Communications © 2009
Page 76 of 128 June 4, 2009
5.2 CLI Command Set
5.2.1 Arp
Use the
arp
command to manually add static ARP definitions to the AN-80i ARP table
(e.g., for wireless link aggragation). A maximum of two static (persistent) entries can be
added to the table. Use the 'save config' command to permanently save changes to the
static entries in the ARP table. Static entries loaded at boot time are recorded in the AN-
80i system log.
Table 14: CLI - arp
PTP PMP Parameter/Description
√
arp <add> <del> <print>
add
Add a new static entry in the AN-80i ARP table. Use 'save config' to
save these entries permanently. A maximum of two static entries
can be added to the table.
<IP> Host IP address. Must be same subnet as AN-80i unit.
<MAC> Host MAC address (e.g., 01-02-03-04-05-06)
del
Delete a static or dynamic entry from the ARP table.
Also see 'clear arptable' command.
<IP> Host IP address of ARP entry to be deleted
print
Print the ARP table. The * indicates manually entered values.
For example:
192.168.25.12# arp print
192.168.25.1
at 00:05:5d:e0:5b:10
192.168.25.22 at 11:22:33:44:55:66 *
192.168.25.33 at 01:02:03:04:05:06 *
192.168.25.201 at 00:05:5d:e0:5b:10
Persistent MACs:
192.168.25.22 at 11:22:33:44:55:66
192.168.25.33 at 01:02:03:04:05:06
5.2.2 Chgver
Use the
chgver
command to change the software version loaded when the AN-80i is
rebooted.
Table 15: CLI - chgver
PTP PMP Parameter/Description
√ √ Enter this command to toggle between software versions. The setting
will alternate between the two banks of memory (no parameters).
chgver
[no parameters]