&
User
AN-80i
Manual
70-00072-01-08b
Proprietary Redline Communications © 2009
Page 89 of 128
June 4, 2009
Table 30: CLI - set
PTP PMP Parameter/Description
it will not be possible to use the CLI interface.
off
- Disable
on
- Enable
Changes to this field are effective only following reboot.
telnetport <value>
Enter Telnet port address (default is 23).
x509auth <on | off>
Enable or disable authentication.
off
- Allow network connections without authentication.
on
- Require authentication using X.509 certificates.
√
View and change PMP parameter settings.
set <parameter>
activekey <key_#> <key_value>
Enable or disable the adaptive modulation function.
key_#
- Options key position: 1 or 2.
key_value
- Options key.
autoscan <on | off>
Enable or disable the Autoscan function.
off
- Disable
on
- Enable
When enabled, the PTP Subscriber (system mode) AN-80i
automatically scans available channels to locate the current
operating frequency of the PTP Sector Controller system.
Executing a set command this field on a PTP Sector Controller
will generate an error message.
bsporten <id> <mode: on | off>
Sector controller Ethernet port enable.
id
-
ID of port
mode
- Set state of port.
off
- Disabled
on
- Enabled
buzzer <on | off>
Enable or disable the audible alignment buzzer. When enabled,
the rate of the tone is proportional to the receive signal strength
(faster = stronger signal).
off
- Disable
on
- Enable
chwidth <value>
Enter the channel bandwidth in MHz. Valid entries are 10, 20,
and 40.
congid <id> <gid>
Connection's group ID.
id
- [id number]
gid
-
gid
conlid <id> <lid>
Connection's Link ID.
id
- [id number]
lid
-
lid
conpri <id> <pri>
