Raven SC1, Calibration And Operation Manual

Page: 35 / 79

Routine Implement Operation: CRX Features and Operation 31
ROUTINE IMPLEMENT OPERATION
CRX FEATURES AND OPERATION
CRX WIDGET DEFINITIONS
The following are common status or mode information which may be displayed on a CRX device while operating
the SC1/TC1 system while in a job:
NOTE: Refer to Diagnostic Trouble Codes (DTC) section on page 53 for additional status conditions which
may be displayed in the SC1/TC1 on-screen widget.
If the SC1/TC1 steering widget does not appear on the screen, refer to the field computer operation
manual for further information on adding widgets.
ENGAGING SC1/TC1
The SC1/TC1 steering may also be engaged using the following methods:
• Tap the foot switch or rocker switch to engage SC1/TC1 features during field operation.
• Select the SC1/TC1 on-screen status widget to engage the SC1/TC1 during field operation.
Display Message
The SC1/TC1 node is detected, but the operator
must accept the operator liability waiver before
the system can be enabled.
No A-B path or guidance line has been set or an
active DTC is preventing the SC1/TC1 system from
engaging.
SC1/TC1 is detected, turned on, and calibrated. A
non-critical DTC is present.
SC1/TC1 is detected, on, and calibrated.
SC1/TC1 is detected and in operation.
SC1/TC1 is detected and in operation. A non-
critical DTC is present.