Raven SC1, Calibration And Operation Manual

Page: 23 / 79

Initial Implement Calibration: Initial Implement Calibration 19
INITIAL IMPLEMENT CALIBRATION
FURROW CALIBRATION
1. Raise the implement and use the Narrow button to adjust the implement to narrowest furrow width.
NOTE: Use the Reverse Hydraulics option as needed to switch the direction which the implement moves
when the button is selected.
2. Measure the width between plough bodies.
NOTE: Do not enter the overall width of the plough. The width between bodies must be measured
perpendicular to the direction of forward travel.
For best results, measure the width of multiple plough bodies and enter the average measurement.
3. Select the voltage button to update the voltage for the minimum furrow width.
FIGURE 20. Minimum Furrow Width Page
4. Select the Next button.
5. Raise the implement and use the Widen button to adjust the implement to widest furrow width.
CAUTION
Hydraulic systems may lose pressure and lower
or drop an implement unexpectedly. Avoid
working under a raised implement. Lower the
implement to the ground or use a mechanical
lock to secure hydraulics before working around
the implement.