R&S QAR Series, User Manual

Page: 25 / 96

Preparing for Use
R&S
®
QAR
25 User Manual 1178.7200.02 ─ 04
Installing the platform
1. Place the platform on a stable and horizontal surface that can support the weight of
the R&S QAR.
2. Check with a spirit level if the platform itself is level.
3. If necessary, remove any irregularities by adjusting the height of the feet until the
platform is level.
● A clockwise movement lowers the corresponding platform area.
● A counterclockwise movement raises the corresponding platform area.
4. Tighten the feet with the check nuts using the open-end wrench.
Figure 4-11: Platform alignment
Mounting the R&S QAR
When the platform is in place, you can mount the R&S QAR on the platform.
Whenever you lift, move or carry the R&S QAR, use the handles on its back side.
1. Screw the two supports to the R&S QAR with four socket head screws (size 5) on
each side of the R&S QAR (see Figure 4-12 ).
2. Lift the R&S QAR onto the platform into a stable position and in a right angle to the
floor.
The position is defined by the two pins on the platform as shown in
Figure 4-12 .
Those two pins fit into the two mounting holes on the frame of the R&S QAR.
Installing the R&S QAR