R&S FSW-K7, User Manual

Page: 258 / 407

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
258 User Manual 1173.9240.02 ─ 23
TRIGger[:SEQuence]:IFPower:HOLDoff <Period>
This command defines the holding time before the next trigger event.
Note that this command can be used for any trigger source , not just IF Power
(despite the legacy keyword).
Note: If you perform gated measurements in combination with the IF Power trigger, the
R&S FSW ignores the holding time for frequency sweep, FFT sweep, zero span and
I/Q data measurements.
Parameters:
<Period> Range: 0 s to 10 s
*RST: 0 s
Example: TRIG:SOUR EXT
Sets an external trigger source.
TRIG:IFP:HOLD 200 ns
Sets the holding time to 200 ns.
Manual operation: See "Trigger Holdoff" on page 103
TRIGger[:SEQuence]:IFPower:HYSTeresis <Hysteresis>
This command defines the trigger hysteresis, which is only available for "IF Power" trig-
ger sources.
Parameters:
<Hysteresis> Range: 3 dB to 50 dB
*RST: 3 dB
Example: TRIG:SOUR IFP
Sets the IF power trigger source.
TRIG:IFP:HYST 10DB
Sets the hysteresis limit value.
Manual operation: See "Hysteresis" on page 102
TRIGger[:SEQuence]:LEVel:BBPower <Level>
This command sets the level of the baseband power trigger.
This command is available for the optional Digital Baseband Interface and the optional
Analog Baseband Interface.
Parameters:
<Level> Range: -50 dBm to +20 dBm
*RST: -20 dBm
Example: TRIG:LEV:BBP -30DBM
Manual operation: See "Trigger Level" on page 101
Configuring the Measurement