R&S 1322.8003K06, User Manual

Page: 386 / 555

Remote Control
R&S
®
FSPN
386 User Manual 1179.4363.02 ─ 01
Example: //Remove spurs
SPUR:SUPP ON
Manual operation: See "Hiding spurs" on page 120
[SENSe:]SPURs:THReshold <Threshold>
This command defines a level threshold for spur removal.
Prerequisites for this command
●
Select Spot Noise vs Tune measurement (
CONFigure:SNTune:MEASurement[:
STATe]
).
●
Turn on spur removal (
DISPlay[:WINDow<n>]:TRACe<t>:SPURs:THReshold
).
The threshold applies to all traces. If you need to define a threshold for each trace sep-
arately (possible in all measurements except Spot Noise vs Tune), use
DISPlay[:
WINDow<n>]:TRACe<t>:SPURs:THReshold
.
Parameters:
<Threshold> <numeric value>
*RST:
0
Default unit: dB
Example: //Remove spurs
SPUR:SUPP ON
SPUR:THR 5
Manual operation: See "Hiding spurs" on page 120
11.6.9 Transient Analysis
● Frequency Configuration .......................................................................................386
● Amplitude Configuration ........................................................................................389
● Data Acquisition .................................................................................................... 390
● Trigger Configuration ............................................................................................ 391
● Y-Axis Scale .......................................................................................................... 394
● Settling Time ......................................................................................................... 398
● Frequency Deviation ............................................................................................. 399
● Trace Configuration ...............................................................................................401
● Marker Configuration .............................................................................................402
● Limit Lines .............................................................................................................402
11.6.9.1 Frequency Configuration
Commands to configure the frequency described elsewhere.
●
Center frequency:
[SENSe:]FREQuency:CENTer
●
Start frequency:
[SENSe:]FREQuency:STARt
Common Measurement Settings