11-4
Next Nine Hours
•
Avoid continuous full throttle operation
•
Verify water pump operation
Bring RIB onto plane and operate engine below 3/4 throttle. DO NOT EXCEED
DO NOT EXCEED
DO NOT EXCEED
DO NOT EXCEED 4500 RPM.
Every 30 minutes, operate engine at full throttle for approximately one minute.
•
DO NOT
DO NOT
DO NOT
DO NOT exceed recommended maximum engine RPM.
= Retorque cylinder head screws after engine break-in period. Retorque after engine has been run and cylinder heads
have cooled to the touch.
Time
0 to10 min 10 min.to 1 hr
.
1hr. to 2 hrs
.
2hrs. to 10hrs.
10 hours or more
Breaking in
engine
At minimum
speed
At closed throttle
At half throttle
Full throttle for 1
minute,at
10
minute intervals
At ¾ throttle or less
At full throttle for
short
i
ntervals
At ¾ throttle
At normal operating speed
Operating range
Approx.3,000 rpm
or less
Approx.4,000rpmo
rless
Approx. 4,000rpm
5,150to5,850rpm
Caution
Caution
Caution
Caution
• The use of inferior or non-standard fuels and oils cannot only shorten engine life but canal so cause starting
problems and lead to breakdowns. Be sure to always use the designated fuel and engine oil types.
• Do not use a gasoline/oil mixture in this engine.
Fuel/Oil Requirements
Fuel/Oil Requirements
Fuel/Oil Requirements
Fuel/Oil Requirements
Recommended Oil
Recommended Oil
Recommended Oil
Recommended Oil
Above 30③ F:
Biodegradable Outboard Oil
Below 30③ F:
100% Fully Synthetic 2-Cycle Engine Oil
Recommended Fuel
Recommended Fuel
Recommended Fuel
Recommended Fuel
Preferred fuel
Preferred fuel
Preferred fuel
Preferred fuels:
Jet A, JP5 or JP8 jet fuel, Diesel DFM-E76, BioDiesel
Alternate fuel: gasoline, gasohol/ethanol
Storage
Storage
Storage
Storage of the Raider Outboard
of the Raider Outboard
of the Raider Outboard
of the Raider Outboard
Use the following procedure to properly prepare the engine for extended periods of nonuse. These steps are intended to
protect the engine during storage and simplify the out of storage servicing procedure.
Note: Use a flushing attachment to prevent engine or water pump damage if you operate the engine on a trailer or dolly.
Safety:When using a flushing attachment, always remove engine's propeller before starting engine
When using a flushing attachment, always remove engine's propeller before starting engine
When using a flushing attachment, always remove engine's propeller before starting engine
When using a flushing attachment, always remove engine's propeller before starting engine to prevent accidental
to prevent accidental
to prevent accidental
to prevent accidental
contact with moving propeller.
contact with moving propeller.
contact with moving propeller.
contact with moving propeller.
Summary of Contents for 50 HP TLDI
