Raider 50 HP TLDI, Service Manual

Page: 173 / 193

10-8
Cause
Remedy(See chapter one)Servicing Information for
specs.)
1-1-1.
Gear shift in forward or reverse position. Shift to neutral position.
1-2-1.
Battery low; or battery cables or circuit line
connections maybe loose or corroded. Recharge or replace battery. Check battery terminal
and cable condition.
1-3-1.
No Fuse in Raider Configuration Maintenance shop repair.
1-4-1.
Severed wire or loose connection.
1-5-1.
Faulty main switch, neutral switch, starter
solenoid or starter motor. Inspect and replace as necessary.
2-1-1. Stuck piston ring.
2-1-2.
Reed valve fails to close,is worn or damaged.
Inspect and repair or replace as necessary.
2-2-1. Fuel is lowor empty in tank or bladder Replenish fuel and perform step 2-2-3.
2-2-2. Air vent is closed. Open air vent and perform step 2-2-3.
2-2-3.
Fuel not coming to fuellines.
2-2-4.
Fuel not fed to fuel lines after tank is filled.
Check primer valve for stiffness. Pinch primer valve,
when it stiffens turn main switch ON for 2 seconds.
Repeat until primer valve is sufficiently stiff.
2-2-5.
Fuel filter is clogged.
2-2-6.
Water in fuel filter.(Indicated by floating of red
float.)
Inspect fuel tank, RIB bladder and engine fuel filters
and clean and replace as necessary.
2-2-7. Air pressure too low in airrail. Refertostep2-3.
2-2-8.
Clogged fuel lines. Check for twisted, flattened or bent fuel lines.
2-2-9.
Trim/Tilt does not function. Confirm no mechanical damage has occurred.
2-2-10.
Components damaged. Replace components.
2-2-11.
Internal leak in hydraulic tiller case. Replace hydraulic unit.