Procedure
Step 1
Access the call settings, as follows:
•
From the XT Series web interface, select Basic Settings > Call-Answer Mode > General.
•
From the endpoint's main menu, select Configure > Calling.
Figure 4-3
Calling preferences
Step 2
Set Confirm Disconnect to Yes.
Step 3
From the web interface only, select Save.
Blocking an Incoming Call
If you do not want to answer a call, you can block an incoming call using the Do Not Disturb
feature. When a remote endpoint calls and you block an incoming call, the XT Series rejects
the incoming call and the call is disconnected. The
icon appears in the system information
area of the monitor display. The caller receives a message to indicate that your endpoint is
currently busy.
To block an incoming call, press and hold the Mute key on the XT Remote Control Unit.
When you block an incoming call as described in this section, the system rejects all incoming
calls until you disable the feature by pressing and holding the Mute key again.
You can configure the XT Series to automatically block all incoming calls, if you want this to
be the default behavior. For more information, see
“Enabling Do Not Disturb to Block All
RADVISION | User Guide for Scopia XT4000 Series Version 3.1.1
Customizing Your User Experience | 62
