RADVision SCOPIA XT4000 Series, User Manual

Page: 27 / 78

Step 5
Use the arrow keys on the XT Remote Control Unit to position the image, and then press
ok/menu.
Step 6
To configure network settings, select Next and continue with “Configuring Network Settings”
on page 22 .
Configuring Network Settings
This procedure describes how to set up the network settings and the IP address the system
uses for placing a call.
Consult with your network administrator to configure these fields.
Before you begin
This procedure is performed as part of the Quick Setup Wizard, after “Adjusting the Image
Position” on page 20 .
To access the quick setup wizard, see “Accessing the Quick Setup Procedure” on page 18 .
Note
If you are modifying the network settings after initial setup, navigate to Configure > Network
> GLAN 1 from the Main menu.
Procedure
Step 1
Press ok/menu and select one of the following from the IP Address Mode list:
•
Automatic: (Default) Select this option if the system gets its IP address automatically
(using DCHP).
The IP address, Subnet mask, Gateway, and DNS fields appear as read-only. See
Table
2-1 on page 23 for a description of these fields.
•
Manual: Select this option if you require a static IP address. This is required, for
example, if the XT Series is connected directly to the Internet, without any address
translation. Enter the fields as described in
Table 2-1 on page 23 .
RADVISION | User Guide for Scopia XT4000 Series Version 3.1.1 Getting Started | 22