Raco Verbatim, Owner'S Manual

Page: 90 / 246

Verbatim Series SFP Autodialer
A-4 Verbatim Owner's Manual
Note:
The procedure of pressing the # key twice, is to be used in relation to all
references throughout this manual to the term, “ENTER.”
In general, if you enter just the three tone digits followed by # #, you will hear
the present setting or value for that program item. If you include additional
values before the # #, the new value will replace the existing setting or value.
In either case, the voice report will provide confirmation of the updated
program setting or value.
Sometimes there is need to include a decimal point or a minus as part of a value
entry. Also, if you make a mistake as you are issuing tone digits, you will want
to cancel the entry. The conventions for these functions are as follows:
CANCEL * *
ENTER # #
POINT *
MINUS #
To end a phone call after programming, press # # without any prior tone digit.
The Verbatim autodialer will then issue a prompting warble tone which is an
opportunity to re-enter a
“1”
if you did not really want to end the call. It will
then say, “Goodbye,” and end the call.
Refer to Section 5.7 for a description of the other command tones that may be
used in place of the
“1”
for special purposes.
A.2 Programming and Testing
The following sections provide a sequential reference to this manual regarding
the relevant differences and similarities in instructions for the Verbatim Series
SFP.
A.2.1 Resetting (Clearing) the Unit
1
Caution:
The following step erases all user programming including recorded messages
so normally it is done only at initial setup.