Raco Verbatim, Owner'S Manual

Page: 33 / 246

Recording Voice Messages
Verbatim Owner's Manual 4-5
v
Exceptions:
u
For any channels programmed for “Status Only” or for Run Time Meter
function, use code 1 ZZ for the Open Circuit message, and 2 ZZ for the
Closed Circuit message.
u
If you run out of recording time, you will hear the message “No more
message time." See Section 4.2 above to re-establish total available
recording time. You may elect to shorten some messages, or rely more on
selected default messages, or you may Autoextend the available recording
time. Then, re-record all messages.
u
If you wish to extend the available time for a specific message while
leaving the other messages unaffected, enter the code for recording that
message, but add an extra digit 1 through 4, before pressing ENTER.
The digit 1 (Rate 1) gives the shortest time and the best sound quality,
while 4 (Rate 4) gives the longest time with poorest sound quality.
u
If you wish to reinstate a default message, enter the code for recording that
message, and an extra POINT before pressing ENTER. For example:
1 ZZ POINT ENTER
u
If you wish to use the default Station ID message but with a different ID
number in place of the “one”, press:
9 1 4 N ENTER
where N is the desired ID number which may be up to 16 digits long.
Some users program the Verbatim autodialer’s own phone number as its
ID number.
u
If you want to set a specific recording rate rather than letting Autoextend
do it, press:
9 1 3 N ENTER
where N is the desired recording rate 1, 2, 3 or 4.
u
You will then need to re-record any messages that were previously
recorded at a different rate.