Quato iColor Display 3.7, User Manual

Page: 16 / 73

16
Software installation for Intelli Proof displays for
Mac OS X
Please insert the CD and open the Disk Image
(.dmg). Copy the iColor Display folder to your hard-
disk.
The Version 3.8.x.x or newer of iColor Display does
not need a driver for the Intelli Proof calibration
interface.
If a driver from an earlier version is installed please
unistall this driver as below:
please remove the following entries from directory
MacintoshHD:\System\Libary\Extensions
SilabsUSBDriver.kext
SilabsUSBDriver64.kext
After removing a restart of your system is requiered.
You can check the status of the device with the Apple
System Profiler (About...-> more Info). The USB-Inter-
face shows up as „CP210x“ (Calibration Processor).
The measurement devices can be connected to your
Mac without installing a driver. iColor Display inclu-
des all necessary device frameworks.
Only for the Basiccolor Discus measurement device
a driver is necessary. It could be found in the iColor
Display.dmg, folder Drivers.
Notice: You need administrator rights to install the
driver. Saving profile in the ColorSync folder also
needs administrator rights.
Notice:
If you have only obtained the iColor Display
Software without Display, skip the installation of the
hardware and just proceed to the introduction of the
software.