![background image](http://html1.mh-extra.com/html/quantum/dlt-4700/dlt-4700_product-manual_3689560081.webp)
Configuring and Operating the DLT4500 Mini-Library
DLT4000/DLT4500/DLT4700 Cartridge Tape Subsytem
4-9
4.5 Test the Installation
This section tells you how to run the power-on self-test (POST) and what to do after
POST.
4.5.1 Run POST
To test the installation for the mini-library by running POST:
1.
Turn on the system power.
2.
Set the power switch on the mini-library rear panel to on.
Result: POST runs automatically when you turn on the mini-library.
3. Watch the display on the mini-library front panel. Ensure the sequence of events is
the same as listed:
Event
Action
1
The message LDR RST
(loader reset) displays.
2
The message LDR ACT
(loader active) displays.
3
A series of numbers display as the mini-library elevator goes up
and down.
4
The message DRV RDY
(drive ready) or the message LDR RDY
(loader ready) displays.
a)
LDR RDY : Cartridge is already in the drive.
b)
DRV RDY: cartridge is not loaded in the drive.
4.5.2 What to Do after POST
Verify whether the POST events took place.
If
…
…
Then
…
…
All the events took place
POST succeeded. The mini-library
Autoloader is ready for operation.
All the events did not take
place
POST failed. See Table 4-1
Summary of Contents for DLT 4700
