Quantum DLT 4700, Product Manual, Page: 39 / 360

Installing and Configuring the DLT4000 Tabletop Drive
DLT4000/DLT4500/DLT4700 Cartridge Tape Subsystem 2-5
2.4 Configure the DLT4000 Tabletop
This section describes how to configure the DLT4000 tabletop drive including:
Topic Section
Configuration Guidelines 2.4.1
Disable Parity Checking 2.4.2
Changing the SCSI ID 2.4.3
The DLT4000 tabletop drive is factory set to SCSI ID 5, unless otherwise specified.
The drive is factory set for parity generation and checking is enabled.
2.4.1 Configuration Guidelines
All systems use the SCSI ID to identify, or address, the DLT4000 tabletop drive.
Follow these guidelines when configuring the DLT4000 tabletop drive for use on your
system:
If you are installing the DLT4000 as
… …
Then
… …
The only SCSI device on the bus or one of
multiple SCSI devices on the bus Be sure to use a SCSI ID that is
unique from any other device or
system ID on the SCSI bus.
The last or only device on the SCSI bus You must terminate the bus by
installing a terminator on the drive.
2.4.2 Disable Parity Checking
To disable parity, see your service representative.
2.4.3 Changing the SCSI ID
Change the SCSI ID via the pushbutton switch on the rear of the drive. Press the
switch button(s) above or below the number display (0-7) to set the desired SCSI ID.
Press the top button to increase the number or press the bottom button to decrease the
number.