![background image](http://html1.mh-extra.com/html/quantum/dlt-4700/dlt-4700_product-manual_3689560052.webp)
Configuring and Operating the DLT4000 Basic Tape Drive
3-6 DLT4000/DLT4500/DLT4700 Cartridge Tape Subsystem
To change the SCSI ID:
1.
Use Figure 3-1, number
•
, to locate the SCSI ID connector on the drive.
2.
Choose a SCSI ID from 0 to 7.
3.
Use Figure 3-3, to see where to place the jumpers for the ID you choose. For
example, if you chose SCSI ID 1, place the jumpers in the same positions as those
in Letter B.
3.2.3 Setting the TRM PWR (Single-ended Only) Jumper
_________________________ NOTE ____________________________
The Small Computer System Interface (SCSI) bus must be terminated at
both ends of the bus, and at least one device must supply terminator
power.
___________________________________________________________
The DLT4000 drive does not have active termination. You can configure the
DLT4000 drive to supply termination power.
To supply terminator power for the SCSI bus:
1.
Use Figure 3-1, number
Œ
, to locate the TRM PWR connector on the drive.
2.
Place jumper in the positions shown in Figure 3-4, number
•
Summary of Contents for DLT 4700
