Quantum DLT 4700, Product Manual

Page: 130 / 360

Configuring and Operating the DLT4700 Mini-Library
5-24 DLT4000/DLT4500/DLT4700 Cartridge Tape Subsystem
5.9.2 Removing a Cartridge from the Magazine
To remove a cartridge from the magazine: at the front of the magazine press in on the
cartridge (Figure 5-5) until it stops and you hear a click. Then, release. The slot has a
spring-release action.
_________________________ NOTE ____________________________
Never apply labels to the top or bottom of tape cartridges. Doing so can
cause cartridge jams in the DLT4700 mini-library. Use the space on the
front of the cartridge for labels.
___________________________________________________________
5.9.3 Removing the Magazine from the Receiver
To remove the magazine from the receiver, first ensure:
1. The Power On indicator is on (Figure 5-2).
2. The Eject indicator is on. (It must be on before you can press the Eject button.)
Then:
1. Press the Eject button (Figure 5-2) to open the receiver. If a tape is loaded in the
drive, pressing the Eject button also causes the tape to unload.
2. Grasp the receiver after it opens (Figure 5-6), and gently pull it forward to access
the magazine.
3. Grasp the magazine's handle only to lift the magazine out of the receiver.
5.9.4 Installing the Magazine into the Receiver
To install the magazine into the receiver:
1. Slide the magazine down into the receiver (Figure 5-6) while holding the
magazine by the handle. Since the magazine is slotted, you can restore it in the
correct orientation only.
2. Push the receiver closed.
3. Observe that the receiver is fully closed in the DLT4700 mini-library before
proceeding.