DLT4000/DLT4500/DLT4700 Cartridge Tape Subsystem 8 5
. .
STATUS phase
is requested by the initiator. The only exception is during error cases when the device
Status bytes the tape drive returns are as follows:
GO
•
REQUEST SENSE command should be sent following this status to determine
•
unable to accept a command from an otherwise acceptable initiator. The initiator
•
for commands issued with the LINK bit set. Following the return of this status,
command.
RESERVATION CONFLICT (18h): This status is returned by the drive whenever
initiator with a RESERVE UNIT command.
COMMAND TERMINATED (22h): This is the status returned for a command
indicates that a contingent allegiance condition has occurred.
NOTE
In contrast to the BUSY status condition, the DRIVE NOT READY Sense
command and indicates that a media access command has been issued
installed, the media has been unloaded, the drive is currently initializing
________________________________
In the not ready state, the initiator cannot perform any operation which would cause
will return a CHECK CONDITION status with a DRIVE NOT READY sense key.
and a GOOD status may be returned.
Summary of Contents for DLT 4700
