Quantum DLT 4700, Product Manual, Page: 42 / 360

Installing and Configuring the DLT4000 Tabletop Drive
2-8 DLT4000/DLT4500/DLT4700 Cartridge Tape Subsystem
2. Snap the wire cable clamps into place to secure the cable.
3. Connect the other end of the SCSI signal cable to the SCSI connector on your
system or, for daisy-chained configurations, to another SCSI device.
See your system documentation for system SCSI connections.
2.5.3 Terminate the SCSI Bus
_________________________ NOTE ____________________________
The SCSI bus must be terminated at both ends and at least one device
must supply terminator power.
___________________________________________________________
Table 2-1 tells you when and where to add a terminator.
Table 2-1 Adding a Terminator
If the DLT4000 is
… …
Then
… …
The last or only device on the bus
and you are
going to terminate the
cables externally
1. Connect the SCSI terminator to one of the
SCSI signal connectors on the DLT4000
rear panel.
2. Snap the wire cable clamps into place or
tighten screws (whichever is supplied) to
secure the terminator.
Not the last or only device on the
SCSI bus Be sure to install the terminator at the end of
the bus.
The DLT4000 tabletop drive can be configured to supply TRM PWR on the bus by
adding a jumper to the pins labeled TRM PWR on the controller printed circuit board
adapter (PCBA).
2.5.4 Connect the Power Cord
To connect the power cord:
1. Ensure the DLT4000 power switch is set to 0.
2. Connect the power cord to the DLT4000 power connector. Make sure the
connector is fully seated.
3. Connect the other end of the power cord to a nearby ac outlet.