Qualitrol 509ITM Series, Manual

Page: 31 / 189

31
www.qualitrolcorp.com
Operation
Automatic Operation
Viewing Channels or Viewing Mode Scrolling
Power Up
When power is applied to the 509ITM, it automatically begins to monitor the input and
controls the output, based on the factory configuration that was specified by the customer.
At power up, the display will Auto Scroll through all of the parameters being monitored at a
frequency of one every two seconds.
MENU Mode
Viewing Channels
(See the Appendix for an example of the menu structure.)
Auto Scroll, MENU, View Mode Scrolling
Press MENU to move the display out of Auto Scroll and into Viewing Mode. The Up and
Down Arrows (or ENTER ) will move you individually through each parameter being
monitored. If no key activity takes place for 60 seconds, the monitor automatically reverts to
Auto Scroll, or press
MENU again to revert back to Viewing Mode Scrolling.
Viewing Reset Relays
(See the Appendix for an example of the menu structure.)
MENU, View Mode Scrolling, Right Arrow
Press MENU to move the display out of Auto Scroll and into Viewing Mode. The Up and
Down Arrows (or ENTER ) will move you individually through each relay that has actuated. If
the relay has been latched and the parameters that actuated the relay are no longer active
then pressing the
RESET switch will clear the relay actuation. If the relay has actuated due
to a rate of change then pressing RESET will clear all the measured rate of change values
and reset the relay. If no key activity takes place for 60 seconds, the monitor automatically
reverts to Auto Scroll, or press
MENU again to revert back to Viewing Mode Scrolling.
Viewing Max Readings
MENU, View Mode Scrolling, Right Arrow, Right Arrow
From Viewing Mode, press the Right Arrow twice. The Up and Down Arrows (or ENTER ) will
move you through the maximum values, as well as the time and date of each parameter
being monitored. Press
RESET to reset all of the maximum readings. If no activity takes
place for 60 seconds, the monitor automatically reverts to Auto Scroll, or press MENU again
to revert the system back to Viewing Mode Scrolling.
Note:
To avoid any erroneous readings caused by the installation, Qualitrol recommends
resetting the maximum values immediately after setting up the monitor.
Viewing Min Readings