![background image](http://html1.mh-extra.com/html/quadro/quadro4li/quadro4li_administrators-manual_3385935032.webp)
Quadro4Li Manual II: Administrator's Guide
Administrator’s Menus
Quadro4Li; (SW Version 5.2.x)
31
SNMP Trap Settings
are used to define the traphosts that
should be informed when certain events occur on the Quadro.
For the listed traphosts to be informed about the events on the
Quadro,
Send SNMP Trap
action should be configured for the
corresponding event(s) from the
page.
SNMP Trap Settings
page contains a list of all configured
traphosts with the referring information.
Fig. II-51: SNMP Trap Settings page
Add
functional button is used to add a new traphost to the table
and opens
Add SNMP Traphost
page where the new traphost
might be defined. Page consists of the following components:
Traphost
text field requires an IP address or the host name of
the traphost. Administrating application’s host address should be
inserted here.
Community
text field requires community description (public,
private, etc.) for the administrating application to accept the
notifications about the certain events on the Quadro. Field may
contain some kind of password which should be the same both
on Quadro and on the administrating application for successful
SNMP management.
A group of radio buttons is used to select the SNMP protocol
version used for events notifications delivered by the Quadro to
the administrating application.
Fig. II-52:Add SNMP Traphost page
Diagnostics
The
Diagnostics
page gives a possibility of running Network and WAN protocol diagnostics to verify Quadro's connectivity and to download all
system logs for possible problems recovery.
The
Start detecting WAN Protocol
button is used to initiate
WAN diagnostics that will detect the WAN IP configurations:
static or through DHCP and PPP servers. For static WAN IP
configuration, gateway availability is checked. When acting as a
client, DHCP and PPP servers' accessibilities are being verified.
The
Start Network Diagnostics
button is used to initiate
network diagnostics, i.e to check the WAN link and IP
configuration, to verify gateway, DNS primary and secondary (if
configured) servers' accessibilities.
The
Download system logs
button is used to download all logs
to the local PC as a *.tar archive file. Logs can be used by Epygi
Technical Support Office to determine the problem occurred on
your Quadro.
The
Reboot this Device
button is used to reboot the Quadro.
Please note that the session with the Quadro will be closed, i.e.
Quadro GUI should be newly opened and new login will be
required afterwards.
The
Start ISDN Diagnostics
button is used to initiate ISDN BRI
low level diagnostic. With these tests the ISDN physical link is
checked and the Frame Synchronization is verified.
The field below will display the diagnostics results and the
connectivity conditions. System should be reconfigured if
problems occur during the diagnostics.
Fig. II-53: System Diagnostic page
Show System Logs
link leads to the page where Quadro’s logs might be viewed, downloaded and the logging setting may be adjusted.
System Logs
The
System Logs
page is accessible by pressing the
Show System Logs
link on the
Diagnostics
page. This page is used to adjust where system
logging settings, view system logs directly in your browser or download them locally to your PC.
The
System Logs
page consists of three sub-pages.