Quadro4Li Manual II: Administrator's Guide
Administrator’s Menus
Quadro4Li; (SW Version 5.2.x)
89
Enable/Disable
functional button is used to enable/disable the corresponding forwarding destinations. This is helpful to avoid removing forwarding
destination(s) if they are not applicable at the moment.
Add
opens an
Add Entry
page where a new forwarding
destination may be specified by its Call Type (PBX, SIP,
PSTN or Auto) and depending on this call type, by its
extension number, SIP address or PSTN number in the
Forward to
text field. Only a SIP registration username can
be inserted here to forward calls to the user registered at the
same SIP server as the current extension is registered at, i.e.
if the SIP server hostname is left empty, the system will
automatically set the current extension's registration server
hostname. The extension number should be inserted in the
Forward to
text field for the
PBX
call type. The
PSTN
number length depends on the area code and phone
number. When
Auto
is selected as a Call Type, routing
pattern will be considered here and parsed through
table.
Fig. II-152: Advanced Settings for SLA# page
Please Note:
System allows you to forward incoming calls to the Quadro PSTN lines, thus giving callers a possibility to make calls through remote
Quadro's PSTN lines. To do so, select
PSTN
from the
Call Type
drop down list and type
pstn
(capital and lower case letters allowed) in the
Forward to
text field. Caller will connect to the available PSTN line, get the dial tone and be free to dial the PSTN number.
Key System Advanced Configuration
The
Key System Emulation - Advanced Configuration
page is used to enable/disable the blind transfer service from SLA lines to extensions or
their voice mailboxes.
The page consists of the following settings:
•
The
Enable blind transfer to VM
checkbox indicates whether
a call received to an SLA can be blind transferred to
extensions’ voice mailboxes. Selecting the checkbox will
enable the blind transfer functionality and will require a
prefix
(digits only) that should precede the calls to voice mailboxes.
To call a voice mailbox, the user should dial the specified
prefix followed by the extension number.
•
The
Enable blind transfer to extension
checkbox indicates
whether a call received to an SLA can be blind transferred to
extensions. Selecting the checkbox will enable the blind
transfer functionality to extensions. You may optionally specify
a
prefix
that should precede the calls to extensions. Specifying
a prefix is mandatory if the extension numbers have the same
length as the SIP usernames on the SIP server on which the
SLA is registered.
Fig. II-153: Key System Emulation - Advanced Configuration page
Please Note:
If the
Enable blind transfer extension
checkbox is disabled, all calls initiated from SLAs are routed to the SIP server on which
the SLA is registered (if any). If the checkbox is enabled but no prefix is specified, outgoing calls will be routed to the SIP server only if the
number of dialed digits does not math the extension length specified on the system.
