QNO FQR7200, User Manual

Page: 38 / 184

Multi-WAN Router
35
Internal LAN IP Range 1 and Internal LAN IP Range 2
respectively.
Enable Line-Dropped
Scheduling:
The WAN disconnection schedule will be activated by checking
this option. In some areas, there is a time limitation for WAN
connection service. For example: the optical fiber service will be
disconnected from 0:00 am to 6:00 am. Although there is a
standby system in the device, at the moment of WAN
disconnection, all the external connections that go through this
WAN will be disconnected too. Only after the disconnected lines
are reconnected can they go through the standby system to
connect with the Internet. Therefore, to avoid a huge number of
disconnections, users can activate this function to arrange new
connections through another WAN to the Internet. In this way, the
effect of any disconnection can be minimized.
Line-Dropped Period: Input the time rule for the disconnection of this WAN service.
Line-Dropped Scheduling:
Input how long the WAN service may be disconnected before the
newly added connections should go through another WAN to
connect with the Internet.
Link Backup Interface: Select another WAN port as link backup when port binding is
configured. Users should select the port that employs the same
ISP.
Shared- Circuit WAN
environment:
If your WAN connects to a Switch, select “Enabled” to filter
broadcast packets. The default is “Disabled”.
MTU:
MTU is abbreviation of Maximum Transmission Unit. “Auto” and
“Manual” can be chosen. The default value is 1500. Different
value could be set in different network environment. (e.g. ADSL
PPPoE MTU: 1492)
The default is “Auto”.
After the changes are completed, click
“Apply”
to save the configuration, or click
“Cancel"
to leave
without making any changes.
Router Plus NAT Mode:
When you apply a public IP address as your default gateway, you can setup this public IP address into a
LAN PC, and this PC can use this public IP address to reach the Internet. Others PCs can use NAT mode to