QED AutoPump AP-2, Operation Manual

Page: 88 / 111

QED Environmental Systems
AP-2 Manual
Page 80
Appendix E: Air Compressor
Installation
The air compressor provides the air necessary to drive the system. The compressed air
normally passes through a single stage filter/regulator and then into the AutoPump System.
WARNING:
The air compressor and any other electrical equipment used with this
pneumatic system must be positioned outside of any area considered
hazardous because of the possibility of the presence of combustible
materials.
Compressors start and stop automatically. Do not place hands or objects on
or near any part of the compressor.
QED Environmental Systems (QED) does not usually supply the air compressor. It is best to
buy the compressor from a local supplier who provides service. Follow the instructions that
accompany the compressor. This appendix is only a general guide, not an in-depth manual
for the compressor.
WARNING:
When compressing air, parts of a compressor can get very hot. Do not touch
the motor, compressor or piping until it has cooled down.
Caution:
The air compressor should be located outside and away from any area which
may contain flammable fumes.
Note:
An automatic drain on the compressor receiver tank significantly reduces
the load on the air filters, extends the life of the filter elements, and
reduces system maintenance. If your air compressor is not equipped with an
automatic drain, you can obtain one from QED.