Starting up
5 — 10
09_0186_0907GB
For the test run, first start the drive motor and then switch on the
pump. Some functions must be checked while the machine is run-
ning.
Notes
Any defects found during these tests must be rectified immediately.
A fresh inspection is necessary after every repair. The machine may
only be put into operation once all the inspections described below
have been concluded satisfactorily.
Close and secure the hood.
Danger
The machine must only be operated with the hood closed.
When closing the hood, the hood interlock must audibly engage.
The hood must also be secured with the lock and the key removed.
Do not exceed the motor speed specified in the “Technical data”
section. Always set the motor to above the speed where it begins to
shake. After periods of intense motor load, do not switch off the drive
motor immediately, but first leave to cool in idling position.
The drive motor can only be started under no load, i.e. no consu-
ming devices should be switched on.
Notes
All consuming devices must be switched off to make starting the
drive motor easier at low temperatures.
Refer also to the documentation of the engine manufacturer.
Continuation next side
5.3
Test run
Starting the drive motor
