Operation
6 — 38
05_0048_0707GB
Set the lever on the switchover valve to the ”High-pressure
cleaner” position.
Open the water supply.
Caution
The high-pressure cleaner must never be run without water. Make
sure that the water inlet is connected correctly.
Press the high-pressure gun trigger and hold it until water runs
out of the nozzle.
⇒
In this way you prevent the high-pressure cleaner from suk-
king in air.
Close the hood again.
Start the drive motor. Refer also to the chapter: ”Starting up” --
section: ”Starting the drive motor”.
Actuate the high-pressure gun trigger.
⇒
The operating pressure can be read off at the pressure
gauge(3).
If necessary, regulate the operating pressure by turning the
handwheel(2).
Do not direct the cleaning jet vertically onto the surfaces to be clea-
ned. Try to ”peel off” the dirt layer from the painted surfaces. Main-
tain a minimum clearance of 30 cm between the cleaning lance and
the surface being cleaned.
Carry out the following steps after cleaning:
Switch off the machine. Refer also to chapter: ”Starting up” --
section: ”Shutting down the machine after operation”.
Open the hood.
Continuation next side
Tip
