Prophete REX BIKE, Operating Instructions Manual

Page: 150 / 436

62 EN
GEARSHIFT
INSTALLING THE REAR WHEEL
1. Place the actuating lever on the hub of the rear wheel. Ob-
serve that the yellow marks of the actuating lever cover the yel-
low marks of the hub (fig. BQ).
2. Place the circlip on the actuating lever and turn it by approx.
45° clockwise. (fig. BP and BQ)
3. Place the rear wheel into the drop-out.
4. Apply the safety washers on the axle so that the interlock is in
the drop-out (fig. BR).
5. Fasten the rear wheel with the axle nuts (fig. BO). Ensure that
the wheel is placed straight in the holder and that the chain
is appropriately tensioned (see chapter Chain tension).
6. Attach the counter-holder bracket on the left side with the
pipe clamp screw connection
1
at the frame (fig. BO).
7. V-brake rim brake: Connect the brake cable
1
(fig. BM)
again.
Hydraulic rim brake: Push the brake cylinder
2
back onto
the cantilever socket
1
(fig. BN).
8. Hydraulic rim brake: Close the quick-clamping lever
3
(fig.
BN) [CLOSE]. If the lever closes too easily, the quick-clamp-
ing screw must be adjusted (see chapter Brakes).
8. Check that the rim brake works properly. Adjust it if neces-
sary (s. chapter Brake).
9. Set the gearshift (s. chapter Setting the gearshift).
1
3
4
BN
1
2
BO
backup disk
chapping nut
BR
switching arm
cover
note
direction
yellow marker
yellow marker
drive unit
ratched
align
BQ
ratched
monting ring
rotate by 45°
for mounting align the
yellow markings on each
other
fix the bracket to the switch arm
properly
BP