PRONAR NV161/1, Operator'S Manual

Page: 76 / 132

Pronar NV161/1
│
NV161/2
│
NV161/3
│
NV161/4
│
NV161/5 SECTION 4
4.10
Connect hydraulic conduits (marked black) of the floor conveyor movement
system to the tractor.
Conveyor connection conduits are marked with decals in the form of
arrows indicating the direction of hydraulic oil flow.
ATTENTION
When connecting the control conduits of the conveyor drive motor, be careful not to
make wrong connections of conduit pairs. Conduits are identified with information
decals.
Connect hydraulic conduits of the control system of the tailgate (marked
green) and slide gate (marked red) (if they are included in the manure
spreader's equipment).
Connect main lead supplying electrical lighting system.
Install PTO shaft (3) according to guidelines specified in the Operator's
Manual of the PTO shaft - figure (4.1).
Connect the PTO shaft end with the clutch on the machine side.
Make sure that the shaft ends on the tractor side and the manure
spreader side fit well and the linkage is properly secured.
Attach chains securing the PTO shaft cover.
Release parking handbrake by turning the crank of the parking brake's
mechanism.
DANGER
When hitching, there must be nobody between the manure spreader and the tractor.
When hitching the machine, tractor driver must exercise caution and make sure that
nobody is present in the hazard zone.
Make sure that there is nothing and nobody inside the load box.
When connecting the hydraulic conduits to the tractor, make sure that the tractor and
manure spreader hydraulic system are not under pressure.
Unhitching the manure spreader
In order to disconnect the manure spreader from the tractor carry out the following actions in
the following sequence.