Chapter 2: Installation
15
Set Up Network Connections
VTrak’s RJ-45 network or Ethernet connectors are on RAID Controller at the
back of the unit. There is one management connection and two iSCSI data
connections.
The following procedures mention a
Host PC
. The Host PC is the PC you select
to directly control the VTrak through network and serial connections.
Storage Area Network
With this arrangement, both management information and data travel between
the Host PC and VTrak over the network. The arrangement requires:
•
Network HBA card, 1 Gb with iSCSI support
•
Network Switch, 1 Gb
Figure 8. VTrak 15200 network connections for SAN
Cautions
•
Where possible, isolate iSCSI data paths from normal
network traffic to optimize the SAN performance.
•
Do not connect a cable between the VTrak Management Port
and your Host PC.
iSCSI 1
iSCSI 2
Mg mt
IO IOI
PROMISE
TECHNOLOGY, INC.
VTrak 15200 Controller
Host PC
VTrak
1 Gb Switch
Management
Port
iSCSI Ports
iSCSI HBA Card
