![background image](http://html.mh-extra.com/html/promise-technology/vtrak-15200/vtrak-15200_user-manual_1617262184.webp)
VTrak 15200 User Manual
176
Set IP Addresses
1.
Be sure the VTrak and Host PC are running, the null modem cable is
properly connected (see page 17) and you have the correct COM Port
settings (see page 20).
2.
Start your PC’s terminal emulation program.
3.
Press Enter once to launch the CLU.
4.
Press 4 to select Network Management then 2 to select Management Port.
5.
Verify that the Management Port has a true IP address.
6.
Return to the Network Management menu and press 3 to select TFTP
server.
Current TFTP Server IP Address: 0.0.0.0
Want to modify TFTP Server IP address(y/n)?>
y
Please enter the new TFTP Server IP address>
192.168.1.157
New TFTP Server IP address is 192.168.1.157
Press Enter key to return
Enter the IP address of the PC/Server where the TFTP Server was installed.
The above address is only an example. See the TFTP Server window to
obtain the actual IP address.
7.
Return to the Main Menu.
Firmware Update
1.
From the Main Menu, press 1 to select Subsystem Management.
2.
Press 1 to select Controller Management then 3 to select Firmware Update.
Please enter the firmware image file
name on TFTP server>
VTrak-01.02.000.54.img
3.
Specify the name of the image file and press Enter.
The name shown above is only an example.
4.
When the CLU informs you that the firmware update is finished, verify that
the VTrak reboots itself. If it does not, reboot the VTrak manually.
This completes the firmware update operation.
Note
You can update the SEP Firmware using the same method as the
Controller, described above. The SEP uses a different file and its
Firmware is revised less often.