Primes MicroSpotMonitor Plus HighBrilliance, Original Instructions Manual

Page: 86 / 116

86
Revision 00 EN - 02/2022
MSM+ HB
35,0(6
9.9.2 Configure advanced settings
1. Click on the Advanced tab.
2. Maintain the options according to the
explanations in the following table..
Option Explanation
Save device settings All options marked with an asterisk in the Device control menu can be
saved in the EEPROM of the device.
These and other options for saving / loading configurations are de-
scribed in chapter 9.4.4 on page 53.
# Pixel in x/y *
This option enables setting the resolution of the CCD sensor:
X
Enter the number of pixels in the x-direction / y-direction in the input
field on the left / right.
Low power mode We recommend enabling this option for relatively low power laser
beams.
If this option is enabled, the following initial values are selected during
beam search
• Filter level of the filter wheel: 0 (instead of 1 otherwise)
• Integration time: 10 ms (instead of 1 ms otherwise).
X
Set the check mark to enable the option.
Locked area Locked area means a restriction of the traversing range in the z-direc-
tion. The lower limit of the enabled traversing range is always home
position. The upper limit can be set freely.
Maximum z-Position in mm *
1. Use one of the following options to set the locked area:
X
Enter the upper limit of the permitted z-traversing range in the input
field.
X
Use the slider below the input field.
We recommend saving a locked area in the device, if it is safety-relevant:
2. If you want to save the locked area (and the other options marked
with an asterisk) in the device, click the
Save device settings
but-
ton.

The settings are retained even if the device is switched off or dis-
connected from the power source.
Tab. 9.12: Options in the Device control > Advanced tab of the Beam pointing measuring mode