Primes MicroSpotMonitor Plus HighBrilliance, Original Instructions Manual

Page: 59 / 116

59 Revision 00 EN - 02/2022
MSM+ HB
35,0(6
Option Explanation
Position in mm Use one of the following options to adjust the position of the
measurement window:
X Enter the x-position / y-position of the center of the measurement
window in the input field on the left / right.
X Position the mouse pointer within the measurement window. Then
drag while holding down the right mouse button.
Find beam This option enables a measurement in which the laser beam is auto-
matically searched for in the entire measurement range. The plane at
the defined z-position is then displayed in the graphic representation.
Measurement window size, integration time, and filter level of the filter
wheel are set automatically.
X Click on the button to start the beam search.
Note that the determined measurement data will not be saved in the
project tree of the Projects tab.
autom. Exposure If this option is enabled, the integration time is set automatically.
X
Set the check mark to enable the option.
Integration time in ms If the autom. Exposure option is disabled, the integration time can be
set manually.
Use one of the following options:
X Enter a value in the input field (0.006 ms to 225 ms).
X Use the slider below the input field.
Filter level The selected setting will only be active if the autom. filter adjustment
option is disabled.
The filter required for measurement depends on the wavelength and
intensity of the laser beam to be measured. We recommend selecting
a filter level that achieves a detector modulation of between 60 % and
80%.
X
Select a filter level in the drop-down list.
autom. filter adjustment If this option is enabled, then the filter levels are set automatically.
X
Set the check mark to enable the option.
Time series A time series consists of several single plane measurements with the
same settings.
Number of measurements * X
Enter the desired number of single plane measurements of the time
series.
Interval between measurements in s *
X
Enter the pause between the single plane measurements of the time
series. This is the time gap between the end of one measurement
and the start of the next.
Parameter settings All settings in the Device control menu can be individually saved for
each device. The saving location is the local installation of the LaserDia-
gnosticsSoftware LDS.
Save current parameters X
Click this button to save all current settings of the connected de-
vice.
Load last parameters
X
Click this button to load the last saved device configuration.
Tab. 9.3: Options in the Device control > Settings tab of the Single planes measuring mode