TABLE C. Options Available for Each Communication Port
Port Port2
Options
X
X
Terminal mode
Calibration mode
X
X
Alarm Configuration
X
X
mode
X
Remote Monitor mode
X
X
Saud
of
or
X
X
Data
Of
Or
X
Data size/stop biis of
or
X
X
Disabled handshaking
X
X
handshaking
Mode
mode of the port. Each communications
operates in
one of these
modes:
Terminal mode
System events are logged immediately as they
occur.
Calibration
Used only by service personnel.
Alarm
you to set up building alarms.
(Not yet implemented)
Computer
Allows you to use Binary Computer Mode (BCM).
yet implemented)
Remote Monitor
Sends
system event information to a remote
monitor panel (RMP). Available for Port 1
Port 1 and Port 2 cannot be placed in the same mode simultaneously; they must
always be operating in different modes. The modes are described in the following
chapter.
Rate
The baud rate of the equipment connected lo this
The baud rate determines the
1
speed of data
the UPS and the connected equipment. For Remote
Monitor mode, the baud rate must be sat
300. All other modes should operate with a
the highest baud rate available
the connected equipment. 300 baud is not
recommended for any mode
than Remote Monitor.
You can select a baud
rate of
or 19,200.
I
Powemare Plus
UPS Communications
7
.
Summary of Contents for Plus 80
